Analogue craft

Film formats explained: 35mm, 120 and sheet film

A woman in a long black and white printed dress stands beside an electric guitar.
Graphic dress and guitar.Photograph by Robert Harper. Robert Harper Photograph Library, Archive.London. From the archive, shown for illustration.

Three families of film cover almost everything in a twentieth-century photographer's archive. The differences come down to how big the frame is and how many you get before reloading.

Almost every photograph made on film in the twentieth century was made on one of three kinds: 35mm film in a cassette, 120 roll film on a spool, or individual sheets. The names are confusing, since one is a width in millimetres, one is a catalogue number and one is measured in inches, but the logic is simple. The larger the piece of film behind each picture, the more detail it holds and the fewer pictures you get before reloading.

This guide explains the formats, their dimensions and what they mean for anyone handling, scanning or researching a film archive.

The three families at a glance

Format Frame size Frames per load Area compared with 35mm Typical use
35mm (135) 24 × 36 mm Up to 36 1× Reportage, travel, concerts, slides for projection
120, 6×4.5 56 × 41.5 mm 15 or 16 about 2.7× Portraits, weddings, editorial
120, 6×6 56 × 56 mm 12 about 3.6× Fashion, portraits, studio
120, 6×7 56 × 70 mm 10 about 4.5× Studio, fashion, still life, landscape
120, 6×9 56 × 84 mm 8 about 5.4× Landscape, architecture
Sheet, 4×5 in about 102 × 127 mm sheet 1 per sheet about 15× Still life, advertising, architecture
Sheet, 8×10 in about 203 × 254 mm sheet 1 per sheet about 60× High-end advertising, fine art

Area figures for sheet film are based on the nominal sheet size; the usable image is slightly smaller because the holder masks the edges.

What is 35mm film?

35mm film began as cinema film. In the 1890s, 70 mm stock was slit down the middle and perforated along both edges to run through a motion-picture camera. Still cameras later ran the same film sideways, using a frame eight perforations long: 24 × 36 mm, twice the size of the original cinema frame, in a 2:3 proportion.

The Leica put the idea into full production in 1925. The form that became universal arrived in 1934, when Kodak introduced the 135 cassette: a light-tight metal can that could be loaded in daylight. The standard full roll gives 36 exposures, with shorter rolls of 24, 20 or 12 also sold.

Its advantages are speed and economy. The cameras are small and fast to operate, lenses are available in every focal length, and thirty-six frames allow a photographer to follow action. Its limitation is the small frame, which must be enlarged more to fill a page.

Positive 35mm film was normally cut into single frames and mounted in card or plastic for projection, which is why "slide" became the everyday word for a transparency.

What is 120 film and what do 6×6 and 6×7 mean?

120 is roll film: a strip about 61 mm wide, without perforations, attached to a longer length of opaque backing paper and wound on an open spool. Kodak introduced it in 1901 for an inexpensive box camera, and it outlasted dozens of rival roll sizes to become the standard for what is now called medium format. The number is a product code, not a dimension.

The film's width fixes one side of the image at about 56 mm. The camera decides the other side, and therefore how many frames fit on a roll:

  • 6×4.5 gives 15 or 16 frames in a 4:3 proportion.
  • 6×6 gives 12 square frames.
  • 6×7 gives 10 frames in a 4:5 proportion, matching a 10 × 8 inch print.
  • 6×9 gives 8 frames in the same 2:3 proportion as 35mm.

A longer version, 220, was introduced in 1965. It dispenses with the backing paper along the film itself and so fits roughly twice the length on the same spool, doubling the number of frames. It needs a camera or film back built for it.

Medium format was the working format of studio, fashion and magazine photography for decades. The reasons are covered in why studios shot medium-format transparencies.

What is sheet film?

Sheet film is exactly that: single flat sheets, one per photograph. The most common size is 4×5 inches, followed by 5×7 and 8×10 inches, with metric equivalents such as 9 × 12 cm. Anything from about that size upward is called large format.

Each sheet is loaded in total darkness into a flat holder, usually one on each side. The holder slides into the back of a view camera, a dark slide is withdrawn, the exposure is made, and the dark slide is replaced. A notch pattern cut into one corner lets the photographer identify the film type and the emulsion side by touch.

It is slow and deliberate, and it offers two things nothing smaller does. One is sheer image area: a 4×5 sheet has roughly fifteen times the area of a 35mm frame. The other is the view camera itself, in which the lens and the film can be shifted and tilted independently. Shift corrects perspective, keeping the sides of a building or a bottle parallel. Tilt reorients the plane of focus, which is how a still-life photographer keeps a receding subject sharp. Our article on jewellery photography on film shows where that matters.

Each sheet can also be developed individually, with processing adjusted for that one picture.

Where do instant films fit?

Instant film was made in forms to fit all three families of professional camera: pack film for backs that attached to medium-format cameras, and single sheets for 4×5 and 8×10 view cameras. Polaroid introduced 4×5 instant sheets in 1958, pack film in 1963 and 8×10 in 1973. In the studio they were used largely as proofs. The print is a unique object with no reusable negative, apart from a few special positive-negative types.

How do I tell which format I am looking at?

A quick identification guide for anyone opening a box:

What you see Likely format
Strip 35 mm wide with sprocket holes along both edges 35mm negative or uncut transparency
Small frame in a 5 × 5 cm card or plastic mount 35mm slide
Strip about 6 cm wide, no perforations, three or four frames 120 roll film
Single frame about 6 cm high in a clear sleeve or black card mask Medium-format transparency
Single flat sheet with notches in one corner Sheet film
Print with a white border and no negative Instant print

Then look at the image itself. If it appears as a normal positive picture, it is a transparency. If tones are reversed, and on colour film the base is orange, it is a negative. For checking a negative's content without a darkroom, photograph it on a lightbox and invert it with the free negative to positive converter, which runs in the browser.

What does format mean for scanning?

Scanning resolution is measured in pixels per inch of film, so the bigger the film, the bigger the file at any given setting.

Format Pixels at 4,000 ppi Megapixels
35mm, 24 × 36 mm about 3,780 × 5,670 about 21
6×6, 56 × 56 mm about 8,820 × 8,820 about 78
6×7, 56 × 70 mm about 8,820 × 11,020 about 97
4×5 in sheet at 2,000 ppi about 8,000 × 10,000 about 80

Large files are not automatically better files. Beyond a certain point, extra resolution records grain and lens softness, not subject detail, and the practical ceiling depends on the film, the optics and the scanner. Storage is the other consideration: an uncompressed 16-bit colour file needs six bytes per pixel, so a 97-megapixel scan is close to 600 megabytes before any copies are made. The film scan resolution calculator and the other free image tools work out dimensions, print sizes and storage for each format.

Which formats are in the Robert Harper Photograph Library?

All three families, in very different proportions. The inventory describes the 52,684 unique analogue photographs as mostly medium-format colour transparencies, with black-and-white negatives, contact sheets, larger-format film, 35mm slides and more than 4,000 Polaroid prints. Some of the music material is recorded as slides, including five sheets of slides of Eric Clapton at the Royal Albert Hall in 1993. The archive also has a small collection of photographs in which cameras and film are themselves the subject: 86 unique photographs across 266 frames.

The inventory does not yet give a count for each film format, and it does not record which cameras or film stocks were used, so none are named here. The counts that exist come from the inventory and have not been checked frame by frame against the physical material. A fuller picture will come from the boxes themselves as they are examined; the analogue photography collection page describes what is known so far. If you are new to working film documents, how to read a contact sheet is a good next step.

Helping to open the boxes

More than half of the archive is still on film and has yet to be scanned, and only a small selection has been published online by Archive.London, and a mixed-format collection of this size is a substantial scanning project. Organisations with experience of digitising roll and sheet film at volume are invited to read the digitisation partners page and get in touch.

Frequently asked questions

What is the difference between 35mm and 120 film?

Size and packaging. 35mm film is 35 mm wide with perforated edges, comes in a metal cassette and gives up to 36 frames of 24 × 36 mm. 120 film is about 61 mm wide, has no perforations, is wound on a spool with backing paper and gives 8 to 16 larger frames depending on the camera.

Is 120 film 120 mm wide?

No. 120 is a product number from Kodak's early numbering of roll films, not a measurement. The film is about 61 mm wide. The frame sizes it produces are described nominally in centimetres, such as 6×6 or 6×7, though the actual image is about 56 mm high.

How many photos do you get on a roll of 120 film?

It depends on the camera. A 6×4.5 camera gives 15 or 16 frames, 6×6 gives 12, 6×7 gives 10 and 6×9 gives 8. The longer 220 roll, introduced in 1965, has no backing paper along its length and gives about twice as many.

What is large format film?

Film supplied as individual sheets instead of rolls, generally 4×5 inches or larger. Each sheet is loaded into a holder in darkness and exposed once in a view camera. The very large frame gives the highest image quality of the common formats, and view cameras allow movements that control perspective and the plane of focus.

Which film format gives the best scans?

For a given film and scanner, a larger frame gives more detail because it needs less enlargement. A 6×7 frame scanned at 4,000 pixels per inch gives about 97 megapixels, against about 21 megapixels for 35mm at the same setting. Whether the extra data is useful depends on the film, the lens and the intended use.

Sources

Published by Archive.London. Corrections are welcome under our editorial policy.

Help digitise the archive

52,684 analogue originals, mostly medium-format transparencies, are waiting to be scanned and catalogued. We are speaking to scanning, cataloguing and tagging partners.

See the digitisation briefWrite to the archive